C2719 Honda NSX

C2720 Honda NSX

C2721 Nissan Z

C2722 Nissan Z

C2717 Toyota Supra

C2718 Toyota Supra

Step 1. Remove digital module.

Remove the dummy module from the base of the car. One screw is all that holds it to the chassis. Remove the screw then gentry prise the module out vertically

Step 2. Separate the contact clips.

Separate the two halves of the module and gently remove the two metal clips.

As they are, they simply pass electricity straight through from the braid wire to the motor wire. There is one clip on each side. The next task is to break this connection so that we can insert our C7006 chip in to the electrical circuit.

Cut the clips in half to produce separated contact plates (see diagram) and file off rough edges. Refit the clips, ensuring that there are no touching edges between one clip and the other along the line of the cut.

Note: The car may only be fitted with the base of the module casing. This does not affect the fitting of the chip.

Step 3. Adjust the sensor boss height.

Reduce the height of the central light sensor boss by about 3mm so that the light sensor pushes through from inside and sits recessed by 2 mm in the mouth of the hole (as viewed from beneath the car).It may also be required to enlarge the hole a little to allow the light sensor to fit all the way in so that the small circuit board holding the sensor rests up against the boss when fitted.

Offer the sensor and its circuit board up to the boss to see that fitment is good. Note that the sensor must not protrude lower than the chassis. The sensor should remain recessed by about 2mm.

Step 4. Prepare the C7006 Digital Chip assembly.

Remove the excess length of the four soldered pins that form part of the plug/socket that holds the two braid wires and two motor wires. This is necessary to allow the board not to foul the inside of the module casing. After cutting them off, ensure that there is no contact between each of the four pins.

Reduce the length of the four wires attached to the plug/socket. These wires need to be soldered to the four metal contact plates, so ensure there is enough length or wire to enable this to be carried out.

Step 5. Install the digital chip in the module casing.

Fit the light sensor and the main circuit board to the module casing. Refer to the picture for the correct orientation.Solder the green and red wires from the chip assembly to the metal contacts on the left hand side of the module casing (i.e. the contacts on the left-hand side of the car. See picture of car chassis layout.

Then solder the yellow and black wires to the contact clips on the right hand side of the module casing.

Step 6. Re-assembly and test.

Re-assemble the two halves of the digital chip casing ensuring that the wires are neatly tucked away inside. If there is no main casing then just use the base section when assembling the electronics. Use insulating tape to protect and cover all metal surfaces from electrical shorts.

Push the module back in to the chassis and insert and tighten the screw gently.

Note: The car may only be fitted with the base of the module casing. This does not affect the fitting of the chip.