Announcement

Collapse
No announcement yet.

Energy-saving mode issue

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • leluiz
    started a topic Energy-saving mode issue

    Energy-saving mode issue

    I am facing two issues:

    - After 20 minutes of non-usage the control unit switches to stand by mode and it does not reactivates even if I press any of the controllers buttons. I have to turn off the CU and turn it on again.

    - When I try to charge the speed controllers, after 20 minutes of charging the CU goes to stand by mode and it stops to charge the controllers. I have to turn off the CU and turn it on again at every 20 minutes to start charging again.

    Any suggestions for these issues?

    Thanks a lot!

  • b.yingling
    replied
    Originally posted by leluiz View Post
    - When I try to charge the speed controllers, after 20 minutes of charging the CU goes to stand by mode and it stops to charge the controllers. I have to turn off the CU and turn it on again at every 20 minutes to start charging again.
    For this one- if you have at least one wired controller, you can plug it in and tape/clamp/fasten the throttle down. I have found that after the initial charge, it doesn't take long to 'top off' the wireless controllers.


    For the other one- that's just the way it works.

    Leave a comment:

Working...
X