Announcement

Collapse
No announcement yet.

Need some Artin Track pieces

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need some Artin Track pieces

    Artin used to make 1/32 scale 1/2 R1 curves. I am looking for some if anyone does not have a use for them anymore.

  • #2
    I have lots of Artin track; $1 a piece

    Comment


    • #3
      I have lots of Artin track; $1 a piece, borders .50 ea.

      Comment


      • #4
        PM sent

        Comment


        • #5
          Still looking.

          Looking for 1/32nd scale 1/2 R1 curves and 1/2 straights. Then will be looking for full straights.

          Thanks.

          Comment


          • #6
            Bump ..

            Comment


            • #7
              another bump.. still looking

              Comment


              • #8
                bump.. still looking

                Comment


                • #9
                  Still looking - Bump

                  Comment


                  • #10
                    Glen, I have a ton of Artin track, some brand new, some used and some with copper tape. You can have the lot for the cost of shipping from Oregon to Maryland. You can see the bulk of the track here: http://www.farroutslotcars.com/FarrO...Baia-Della-Sud

                    There's even more available.

                    Comment


                    • #11
                      Fall Bump. Still looking for Artin track just sitting in one corner collecting dust.
                      Looking for a bunch of stuff. R1, R2, std straights and half straights.

                      Comment


                      • #12



                        I have a large 4 lane set i will be bringing to the slot car show in white marsh in the morning. I want to sell it as a set.
                        Includes 2 electronic lap counters and a pair of crossover lane sets as a bonus.
                        I have set it up two different ways; the two designs are in my 'Artin track' gallery. Table is 13 ' x 6'. Obviously other configurations possible.
                        Last edited by burad; 10-21-2017, 04:40 PM.

                        Comment


                        • #13
                          Hey Brad, Was planning on being there.

                          Comment


                          • #14
                            Glen, when you get this thing built, you gotta post some pictures!

                            Comment

                            Working...
                            X