Announcement

Collapse
No announcement yet.

Mga

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Hi John,

    This is another car that is right up my street, good choice! You've made a good job so far and it's nice that you've been able to keep the interior.

    I have the Monogram MGA kit and was put off because the shut lines were moulded on top of the bodywork. Is your kit the same? I've noticed you've shaded yours with some black paint, did you cut them in first?

    Keep up the good work,

    Pete

    Comment


    • #17
      Pete, thanks very much for your post!

      Your cars are so very well done, I really like the club racing look of the builds you do.

      Yes the shut lines were molded and raised on the Monogram MGA so I sanded them down and scribed over the lines to create recessed shut lines. In retrospect I made the lines too wide with the tool I used and I will try not to make the same mistake again.

      I hope to have some time this evening to get a start on the driver.

      Thanks again

      John

      Comment


      • #18
        I had some time last night to work on the driver for the MGA.

        Although not yet complete, here are some photos of the figure so far:









        As always, any and all comments are more than welcomed.

        Thanks

        John

        Comment


        • #19
          I managed to finish the driver and place him in the driver's seat.

          Here is the competed car:





















          I look forward to any and all comments.

          Thanks

          John

          Comment

          Working...
          X