Hi guys, received the cars yesterday, will unpack today and try to qualify them in the next couple of days. My plan is to run the race over this weekend.
Jack
Last edited by kidvoltage; 07-13-2012 at 08:14 PM.
Started unpacking cars, first car out was Ronan's Alfa with the sticky note about the stripped crown gear. I have plenty of crown gears but his axle figures .251. All my crowns fit .238 axles. It also appears that the wheels are plastic (must be CA glued on) I dont want to break any wheels and I have no crown gear to fit. I could put different bushings in with my axle and crown and use a pair of set screw wheels with Ronan's tires (tires on his car are not glued although it looks like they were glued at one time.
I don't have a problem doing this but I need Monte and /or Ronan to advise me ASAP.
Hey guy's , much too hot to finish this race today, will complete it tomorrow or Tuesday. I have run the Green lane two times for a total of 6 minutes. The results are in the attached spreadsheet.
I still have to run the Yellow lane and, as the cars have not been on Yellow, this could be the "wild card" in the outcome.
To date, only 1 foot separates 1st #38 & 2nd place #11. The 3rd place car # 22 is just 6 feet off the pace. A lot of great cars with some very close lap totals throughout.
Round 12 Red Mountain Raceway
Help !!
It also appears that the wheels are plastic (must be CA glued on)
I dont want to break any wheels and I have no crown gear to fit. I could put different bushings in with my axle and crown and use a pair of set screw wheels with Ronan's tires (tires on his car are not glued although it looks like they were glued at one time. 
read it and weep 
Linear Mode
