Announcement

Collapse
No announcement yet.

Chassis flattening

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Boopie, if you leave the pod in the chassis, it will help align everything. After straighteneing, I check bushing alignment on the chassis jig just to be sure.

    Comment


    • #17
      High temp required on many Chassis.

      Boopiejones, that procedure works fine on some chassis, will not touch an Avant Slot. nor BRM. They require higher temperatures. This is part of the discussion here. The normal way, as suggested by Slot.it will not straighten some chassis, but slowly up the temp and you can usually get the results needed. Timkoul's temp is very high so just making sure he is doing it the same as you, and I described.

      I have a machined flat metal plate, but otherwise I am doing similar to you. Higher temp water, I boil in a kettle before filling the flat glass pan. Then I sit in an oven at higher temp than you, 220 for Slot.it, 250 for BRM and so far Avant Slot, but may try higher. Critical complete chassis is covered.
      I leave in the oven for about 15minutes with heat on then switch off and allow to cool overnight.
      Alan Smith
      SCI Owner.
      www.scaleracing.com
      www.slotcarillustrated.com
      www.facebook.com/scaleracingcenter
      www.132slotcar.us

      1-253-255-1807

      Comment

      sex vidio
      antalya escort
      tsyd.org/lisansli-canli-bahis-siteleri-2022-guvenilir-bahis-siteleri
      lara escort escort istanbul escort sirinevler escort antalya
      atasehir escort taksim eskort lara eskort bayan bakirkoy bayan eskort
      gaziantep escort
      gaziantep escort
      erotik film izle Rus escort gaziantep rus escort
      bahisnow giriş casinoslot sultanbet giriş grandpashabet giriş
      kadikoy escort kartal escort
      eurocasino
      brazzers
      Blonde and brunette dirty 3some in semi obscure Профессор трахнул студенту толстым хером pelicula embarazada por accidente
      Working...
      X