Tweet
Hi Guys,
Long awaited and over promised I'm sure..........
I would like to officially announce the beginning of a new Bi-Yearly race. I am looking to do something cheap and fun. Here is what I have come up with.
Rules
Chassis
- H&R Inline chassis kit. See HRCH10 for the exact kit
- All stock parts must be used
- Chassis straightening allowed
- Rear bushings can be soldered in (must be in stock location)
- Maximum chassis width is 95mm
Motor
- Handout the morning of the race (same as the kit motor)
- All motors will have pinion and wires on them
- Leads will be fed through guide and your braid pushed in (no guide clips allowed)
Tires
- Rears are handout the morning of the race. Skinny Silicones 12mm width, on the H&R wheel.
- Front foams may be trued down to minimum of 25mm
- No hardening of the foam in any way. Other than leaving them out in open air
Guide
- Stock white H&R guide
- Guide may be shimmed down for maximum depth
Body
- Any 1/24 or 1/25 Scale Truck, Van, Mini Bus, El Camino or the like, Pick Up Truck, Panel Van, or Station wagon, or..............the vehicle must be able to carry a "load" of construction materials. What ya got???
No body can be wider than 95.25mm, or else there won't be any passing.
The Date - Tentative - Thinking Nov 29th now.......
Format - Half Enduro (8 Minute heats) South Loop (The Spring run will be North)
Race Fee - $10 - Includes Pizza and a pop/water
I have everything you need to build your ride at the store. Including a few new model kits that qualify.
Questions, please ask!
Ron
Race Haven Hobbies
www.racehavenhobbies.com
Long awaited and over promised I'm sure..........
I would like to officially announce the beginning of a new Bi-Yearly race. I am looking to do something cheap and fun. Here is what I have come up with.
Rules
Chassis
- H&R Inline chassis kit. See HRCH10 for the exact kit
- All stock parts must be used
- Chassis straightening allowed
- Rear bushings can be soldered in (must be in stock location)
- Maximum chassis width is 95mm
Motor
- Handout the morning of the race (same as the kit motor)
- All motors will have pinion and wires on them
- Leads will be fed through guide and your braid pushed in (no guide clips allowed)
Tires
- Rears are handout the morning of the race. Skinny Silicones 12mm width, on the H&R wheel.
- Front foams may be trued down to minimum of 25mm
- No hardening of the foam in any way. Other than leaving them out in open air
Guide
- Stock white H&R guide
- Guide may be shimmed down for maximum depth
Body
- Any 1/24 or 1/25 Scale Truck, Van, Mini Bus, El Camino or the like, Pick Up Truck, Panel Van, or Station wagon, or..............the vehicle must be able to carry a "load" of construction materials. What ya got???
No body can be wider than 95.25mm, or else there won't be any passing.
The Date - Tentative - Thinking Nov 29th now.......
Format - Half Enduro (8 Minute heats) South Loop (The Spring run will be North)
Race Fee - $10 - Includes Pizza and a pop/water
I have everything you need to build your ride at the store. Including a few new model kits that qualify.
Questions, please ask!
Ron
Race Haven Hobbies
www.racehavenhobbies.com
Comment