I’m trying to use my professor motor pmtr1071 wiring center for 4 lanes positive polarity. Power comes from my trackmate relay into the wiring center. I made three wire controller boxes and wired as instructed. The problem I’m having is three lanes the brakes aren’t able to be adjusted and on one lane, it’s not letting me use any brake. That lane also won’t light up the green light on my PM controller. Any ideas? I’m ready to unhook it all and start all over and don’t want to have to buy new wire and spend my time. Hopefully someone has a fix. Thanks!
Announcement
Collapse
No announcement yet.
Professor Motor Wiring Center
Collapse
X
-
I believe I figured it out. I wired everything and still had problems with lane three. I tested all the breakers with a diode tester and all seemed good. So I loosened all the breakers and connectors and gave them all a little move and tightened everything back down. Now it works. I think the PM pmtr2111 brake pot is too low a resistance to notice any less breaking. The slot.it controller works great.
Comment